Rare to see in this conditon and so little use, unmarked, huge dollars in Australia to replace nand $650 plus $20 post Australia wide will see it sell fast. They never last long, dont delay.
email brenton@posnav.com.au
cheers Brenton vk3cm

RigExpert AA-600

RigExpert AA-600, AA-1000 and AA-1400 are powerful antenna analyzers designed for testing, checking, tuning or repairing antennas and antenna feedlines. Graphical SWR (Standing Wave Ratio) and impedance, as well as Smith/polar chart displays are key features of these analyzers which significantly reduce the time required to adjust an antenna. Easy-to use measurement modes, as well as additional features such as connection to a personal computer make RigExpert AA-600, AA-1000 and AA-1400 attractive for professionals and hobbyists. The following tasks are easily accomplished by using these analyzers:

• Rapid check-out of an antenna

• Tuning an antenna to resonance

• Antenna SWR and impedance measurement and comparison before and after specific event (rain, hurricane, etc.)

• Making coaxial lines or measuring their parameters

• Cable testing and fault location

• Measuring capacitance or inductance of reactive loads

• 0.1 to 600 MHz

• 1 kHz resolution

• 1 to 10 in graph mode
• 1 to 100 in numerical modes

• 0…1000, -1000…1000 in graph mode
• 0…10000, -10000…10000 in numerical modes

• R, X graph, 80 points
• Smith (or polar) chart, 80 points
• SWR at single or multiple frequencies
• SWR graph, 80 points
• SWR, return loss, R, X, Z, L, C at single frequency
• TDR (Time Domain Reflectometer) graph

• Connector type: N
• Output power: -10 dBm (at a load of 50 ohms)
• Output signal shape: square, 0.1 to 200 MHz. For higher frequencies, harmonics of the main signal are used.

• Max. 3 hours of continuous measurement, max. 2 days in stand-by mode when fully charged batteries are used
• Three 1.2V, 1800…3000 mAh, Ni-MH batteries, type AA
• When the analyzer is connected to a PC or a DC adapter with USB socket, it takes power from these sources