1300 Rotator with CR-4P Preset Full Circle Display Controller.
Includes Top Mast Clamp, Plug For Control Cable + revised manual .
Wind Area ................3.0m Sq.
Rotation Torque ..... 30.0 Kg/m
Brake Torque ......... 250 Kg/m
Mast Size ................ 48 ~ 63mm
Rotation Time ........ 70 second 360 degree
Control Cable...........7 core
Rotator Voltage ..... 25vAC
Rotator Weight........5.5Kg including mast clamp.
The CR-4P Controller:- Full Circle Display with LED illumination, Momentary + lock direction switches + Dial prese control.
Fully disassembled, cleaned & prepared rear panel for upgrades.
The Front panel:- Replaced compass direction display with late version, Installed two small LED's into the end of the needle, Blue for direction & red for limit action all controlled by my New yLED-dc+Limit PCB.
The Back Panel:- Was stripped down re-painted & then fully re-labelled, Installed a new 7 way terminal barrier, New fused IEC 240v socket & earth bolt + Output put voltage select terminal.
On the Inside:- Installed the new yLED-dc+Limt PCB, Refurbished the display POT as well as the display gear assembly, Upgraded the display illumination with 2 x 5mm LED's, Installed 10 turn adjustment POT's & terminal blocks to the PCB's, Re-configured wiring.
Fully tested & aligned with the 1105 rotator.
The 1300 Rotator :- Has twin solid final drive gears & BK spring brake system.
Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.
All housing & the New Create mast bracket were Glass Bead Blasted, followed by Etch Priming then finished off with a top coat epoxy Enamel Pewter.
Replaced gear shafts with upgraded versions & affixed them to into the lower gear chassis. Replaced the limit switches, Installed new 5 turn 500 ohm POT with new drive gear & stainless steel mounting bracket, Replaced the control cable socket with New 7 pin LTW version & S/S cover plate.
The gears were aligned & shimmed then re-assembled into the refurbished housings with new bearings & new grease through out.
Install new upgraded Create MC-2 mast bracket assembly onto the top housing, includes all GAL H/W. .
Re-aligned & calibrated to the CR-4P controller.
240v AC, 24 month warranty.
This unit is available for exchange, see details on my web site.
Please contact me (Peter of Duoro Services) via the embeded email service provided by VK Classifieds.
Paypal
Direct Deposit
Cheque
Cash