EMOTATOR 1105 CR-4P Rotator Set

$ 1,250.00
Nov 23, 2022
Quantity Available

Emotator 1105 Rotator with CR-4P Preset Full Circle Display Controller.

Includes Top Mast Clamp, Plug For Control Cable + revised manual .


Wind Area ................2.5m Sq.

Rotation Torque ..... 8.0 Kg/m

Brake Torque ......... 100 Kg/m

Mast Size ................ 40 ~ 61mm

Rotation Time ........ 75 second 360 degree

Rotator Voltage ..... 24vAC

Rotator Weight........5.2Kg including mast clamp.


The CR-4P Controller:- Full Circle Display with LED illumination, Momentary + lock direction switches + Dial prese control.

Fully disassembled, cleaned & prepared rear panel for upgrades.

The Front panel:- Replaced direction compass display with late version, Installed two small LED's into the end of the needle, Blue for direction & red for limit action all controlled by my New yLED-dc+Limit PCB. 

The Back Panel:- Was stripped down re-painted & then fully re-labeled,  Installed a new 7 way terminal barrier, New fused IEC 240v socket & earth bolt + Output put voltage select terminal.

On the Inside:- Installed the new yLED-dc+Limt PCB, Refurbished the display POT as well as the display gear assembly, Upgraded the display illumination with 2 x 5mm LED's, Re-configured wiring.  

Fully tested & aligned with the 1105 rotator.

The 1102 Rotator :- Has twin solid final drive gears & BK spring brake system.

Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.

All housing & the mast bracket were Glass Bead Blasted, followed by Etch Priming then finished off with a top coat epoxy Enamel Pewter.

Some steel brackets & plates have been re-zinc plated, All gear shafts have been affixed to into the new replacement lower gear chassis. Replaced the limit switches, Installed new 5 turn 500 ohm POT with new drive gear & stainless steel mounting bracket, Replaced the control cable socket with New 7 pin LTW version & S/S cover plate. 

The gears were aligned & shimmed then re-assembled into the refurbished housings with new bearings & new grease through out.

The mast bracket now has new larger 10mm S/S 'U' bolts + my new stainless steel mast clamps. 

Re-aligned & calibrated to the CR-4P controller.

240v AC, 24 month warranty.

This unit is available for exchange. See details on my web site.
Contact Peter via the embedded email servive provided by VK Classifieds.

Accessories Included
Mounting Bracket
Payments Options
  • Paypal
  • Direct Deposit
  • Cheque
  • Cash
Condition of Item - Commercial
Postage - Freight
Buyer Pays
Your Friend’s Name *
Your Friend’s Email *
Contact Seller

To contact the seller please

Sign in
Search for a city or select popular from the list
Select a label or click "Other" to send comments
Are you sure you want to cancel your report?
Sign in