Rotator With A Full Circle Pre-set Controller With Multi Voltage Output, Refurbished & Upgraded.
Includes Top Mast Clamp & S/S mounting clamping hardware, Plug for the control cable, revised & upgraded manual inc new schematic.
Wind Area ...............1.5m Sq.
Rotation Torque ..... 6.0 Kg/m
Brake Torque ......... 40 Kg/m
Mast Size ............... 38 ~ 62mm
Rotation Time ....... 64 second 360 degree
Rotation stops .......Mechanical & Electrical
Control Cable .........7 core with limit feed back to the controller
Features...................Manual & lock direction switches, Dial Preset, Multi voltage output,
LED display illumination inc end of needle, Limit indicator in needle
Rotator Voltage ..... 24vAC.
The CR-4P Controller:-
Manual & lock direction switches, dial pre-set control & full circle display. Refurbished & upgraded etc.
Cleaned & upgraded.
On the insides:- I installed LED display illumination including the needle end, Needle also has the rotation limit indicator in it which is controlled by a small PCB via the originally unused terminal 4 on the back of the controller, Replaced the cracked gear in the display drive assembly & also refurbished the POT.
On the back panel:- Installed new wiring selection chart.
Re-wired, re-calibrated & aligned to the upgraded DR-7600 rotator.
Includes revised & upgraded manual including schematic.
The DAIWA DR-7600 Rotator:-
This rotator has been upgraded, reconfigured & rewired to suit the CR-4P controller.
Fully striped down, cleaned & checked all parts for damage etc, Affixed the gear shafts into the lower gear chassis.
The original 4 stack final drive gear was replaced with my KD-38T solid thicker gear version. Install new limit switches with limit rotation feed back to the controller, Fully re-wired to new 7pin round LTW socket which is mounted on a new S/S cover/mounting plate.
The housings & mast clamps were Glass Bead Blasted then etched primed followed by painting in Pewter Epoxy Enamel. I install M8 RECOIL inserts into the top & bottom mast clamp mounting holes as well as into the threaded side if the mast clamps. Reassembled with new ball bearings & new grease through out. Aligned & calibrated to the CR-4P controller.
Supplied with 7 pin IP67 plug & S/S mounting/clamping hardware.
230v AC. 24 month warranty.
This unit is available for exchange, see details on my web site.
Paypal
Direct Deposit
Cheque
Cash