CREATE RC5-1 Rotator Set, Refurbished etc

Rotator & Controller Set :- Includes:- Top mast clamp, Plug & terminals for control cable, GAL mounting & clamping hardware & Manual. Requires 7 core control cable not supplied but sold separately, please view cable available on the rotator spares page.

Wind Area .............. 1.2 m sq.

Rotation Torque ..... 6.0 kg/m

Brake Torque ......... 80 kg/m

Mast Size ............... 48 ~ 63mm

Rotation Time ........ 75 ~ 110 seconds 360 degrees

Rotator Voltage ..... 28vAC.

The -1 Controller :- Has variable dial speed control (75 to 110 seconds for 360 degrees)  with a full circle compass display with a single on-off-on manual direction paddle switch.

The controller was completely stripped down & upgraded with NEW parts.

New Parts installed:- PB-1 PCB, 7 way output terminal barrier, Display drive gearing, POT for Speed Control, LED illumination, Limit LED, IEC power socket & safety power lead, M4 earth bolt.

Completely re-wired the whole controller. 

Has be fully checked & aligned with the RC5-1 rotator below.

The RC5 Rotator :- Has 1/60 worm drive into two stage reduction gearing, all driven by a high torque 28v AC motor.

Able to rotate a full 380 degrees. It has low back lash with high rotation torque & powerful braking without relying on any auxiliary brake mechanism. With a total of only four gears, two of which are made from high tensile steel & the other two are made from zinc alloy, all running on high tensile steel shafts.

Includes:- Top mast clamp & mounting hardware + plug & terminals for control cable.

Completely stripped down & cleaned.

Has been refurbished & updated with @ least 50% NEW parts.

NEW Parts list:- Top & bottom housings, MC601 Output flange, Top Mast clamp set, Coupling assembly, Shafts for Worm Gear & Worm Wheel, Drive Gear shaft, Final gear  shaft, POT gear, 500 ohm POT & mounting bracket, Weather Seal & Screw cover cap, Both plug & socket for control cable, Fully re-wired. 

The Worm Gear/Worm Wheel chamber was upgraded & sealed better for the new Bel-Ray 00 white fluid grease I use the chamber.

The Main & Drive gears were installed into the housings with new grease through out. 

Aligned & calibrated to the RC5-1 controller.
24 month warranty, 230vAC input