Includes top mast clamp, plugs for control cable & IEC power lead + revised manual.
Wind Area .............. 1.16m Sq.
Rotation Torque ..... 9.3 Kg/m
Brake Torque ......... 58.0 Kg/m
Mast Size ............... 50mm
Rotation Time ....... 60 second 360 degree
Control Cable ........Upgraded to 7 core
Rotator Voltage ..... 24vAC.
The HAM2 Controller :- Refurbished & upgraded to dual action direction switches (No more holding down the brake switch + the direction switch), upgraded to 7 core control cable.
Completely disassembled for mods & upgrades including removing the rear panel.
Upgrades:- New BDS-35 Auto brake & delay PCB, Converted from 3 lever action to dual action two levers including 4 new micro switches, Replaced the rear panel with a laser cut & etched stainless steel panel with NEW fused IEC & Cinch sockets + new CAL/NORM switch & earth bolt,
The original control PCB was replaced with one of my Prototype new version which has 12v output to drive the newly install LED display illumination, Also installed a new display transformer to suit the replacement PCB.
Added 3 LED's for brake & direction action, Replaced the main transformer with a 240v 160va Toroidal version, New illuminated power switch & CAL POT.
Fully re-wired, aligned & calibrated to the rotator.
Includes IEC power lead & Cinch plug.
The HAM2 Rotator :- This rotator has a solenoid activated brake 'V' wedge system.
This rotator was rebuild with NEW & refurbished parts, (inc S/S mast clamps & S/S hardware, CAP, Bearings, Cinch socket & plug, hardware etc.
The NEW motor had to be stripped down as it was not working properly, polished the drive shafts & fixed the friction brake, then bolted it back together.
The Solenoid brake assembly is good condition with new hardware.
Contact Peter on 0427 043 054 (NO SMS) or via VK Classifieds email service.
Paypal
Direct Deposit
Cheque
Cash