Antenna tilt mount for vertical antenna

This listing is for 1 x Antenna Tilt mount to suit a vertical antenna.

Single person tilt to bring the antenna top down to ground level.
Perfect if you need to raise/lower your antenna whilst experimenting.

Hand made in the USA, I purchased this tilt mount for a vertical project that won't proceed.
It is brand new, comes with 2 inch clamps to attach your vertical antenna.
Very strong construction of steel and aluminium.

From the manufacturer's web-site:
Antenna Tilt Mount for vertical base antennas. Stronger and much improved over the MFJ-1903 and the Intellitron AB-1612. Individually made (not mass produced) from 6061 four inch aluminum channel  and 3/16  mild steel that is used to make the outer channel. 

There is No Flex with this new stronger design. Pivots / hinges on a large robust 7/16  pin / bolt rather than the two small 5/16 bolts that are used on the MFJ-1903  and Intellitron AB-1612 models. Is secured in place when in the "Up" position by two bolts that thread into the channel rather than using nuts and bolts as the MFJ-903 did. This allows for easier securing without having to reach inside the channel to hold the nuts with a wrench.

This tilt mount comes with four (4) U-bolts. Two for the "Antenna" tilt-over side and two for the stationary side. Included U-bolts work with mast or pipe up to two (2.0) inch outside diameter.

The last four images are from the manufacturer's web-site.

Will post anywhere in Australia.