Category: Main > Commercial - Dealer Only > Rotators

HyGain T2X Rotator & a DUORO CR4HG Controller  - $995 Listing ID: 15484



Classified Info

Listing Began: Sep 16 16:08
Number of Times Viewed: 78

15-09-002a.jpg

  • 15-09-002a.jpg
  • 15-09-003a.jpg
  • 15-09-005a.jpg
  • 15-09-006a.jpg
  • 15-09-010a.jpg
  • 15-09-009a.jpg
  • 15-09-011a.jpg
  • 15-09-026a.jpg

Videos


Options

  • $80

Description

Seller's Comments and Description:

Refurbished & Upgraded With Lots Of NEW Parts.
Includes Top mast clamp & mounting hardware, Plug for control cable & IEC power lead + revised manual.
The CR4HG Controller:- Full circle display with momentary & lock direction switches.
This controller was formally a Daiwa CR4, it was fully striped down, reconfigured & fully upgraded to work with the HyGain T2X rotator.
Upgrades:- Replaced the display PCB with one from a Emotator controller which was upgraded + installed a Emotator 8v transformer, Install my BDS-35 Auto Brake Release & Delay PCB, Replaced the original 9 way screw terminal block with a NEW 7 way version from Create controllers, Installed LED display illumination & there power supply, Fully re-wired & upgraded to 7 core control cable.

The HyGain T2X Rotator:- Has a friction brake inside the motor with a solenoid activated wedge brake system.

This rotator was rebuilt with about 95% NEW parts inc. all housings & chassis, Motor, Limit switches assembly, 500 ohm POT, Steel ring gear, Bearing & retainer, Cinch socket & plug, hardware etc.
The solenoid brake assembly was from a display unit I purchased & in very good condition.
Upgrades:- Control cable is now 7 core (instead of 8) by way of moving the motor start CAP into the rotator which used terminals 4 & 8, the new wiring configuration uses the vacant terminal 4, Install New direction POT, Replaced screw terminal block with a Cinch socket & new cover plate, Mounted the motor start CAP, added a (protection/safety) micro switch on the motor's 0v which is activated by the wedge latch (if the brake wedge does not release the motor will not go), Mast clamp bracket upgraded to my NEW stainless steel version with new S/S 'U' bolts.
The housings are as I got them from HyGain (Natural Aluminium), as this build was becoming way to expensive to do a proper paint job on them. Shimmed & aligned gears, installed the new bearings & retainers, then reassembled with new grease through out. Re-wired, Aligned & Calibrated with the CR4HG controller.
Includes top mast clamp & hardware + Cinch plug for the control cable.

240vAC. 24 month warranty.
Contact Peter of Duoro Services on 0427 043 054
This rotator is available for exchange see details on my web site.


Details

Manufacturer HyGain & Duoro
Model T2X & CR4HG
Condition of Item Excellent
Accessories Included Top mast clamp & hardware, Plug for control cable, IEC power lead + revised manual
Postage / Freight Pickup Available





Advertisement

Next >>