Category: Main > Commercial - Dealer Only > Rotators

AIGA ART-3000c-DS Rotator Set Serviced & Upgraded  - $350 Listing ID: 15115



Classified Info

Listing Began: Oct 2 8:05
Number of Times Viewed: 506

11-08-007a.jpg

  • 11-08-007a.jpg
  • 11-08-008a.jpg
  • 11-08-009a.jpg
  • 11-08-010a.jpg
  • 11-08-011a.jpg
  • 10-08-008a.jpg
  • 10-08-010a.jpg
  • 11-08-001a.jpg

Options

  • $60

Description

Seller's Comments and Description:

Basic Refurbishment,Serviced & Upgraded.
Panel metered 'C' version controller & 3000 rotator with top mast clamp, plugs for control cable, IEC power lead, hardware & revised manual.

Wind Area...........................0.5m Sq.
Rotation Torque..................8.0 Kg/m
Brake Torque......................17 Kg/m
Brake type..........................Disc & cork pads

Mast Size............................35 ~ 54mm
Rotation Time.....................60 seconds 360 degrees
Control Cable......................7 core
Rotator Voltage...................100v AC

The 'C' Version Controller:- Serviced & Upgraded etc to DS version.
Has panel meter direction display with LED illumination, End of rotation lamp & all metal housing/chassis.
Disassembled, cleaned & prep chassis for upgrades & new parts.
On The Front Panel:- Installed a new illuminated power switch. 
The Back Panel:- Installed a new 8 pin Cinch socket & laser cut S/S cover/mounting plate, New fused IEC 240v power socket & earth bolt.
On The Inside:- Added a seperate transformer for the PCB & illumination, Upgraded display illumination to a 3 LED module & there power supply. Moved the motor start CAP to the rotator. Replaced original NON PCB circuit with an upgraded PCB from a Kenpro KR-400. Fully re-wired & upgraded from 8 core control cable to 7 core.
Re-assembled, fully tested, aligned & calibrated with the rotator.
Supplied with new safety IEC power lead & 8 pin Cinch plug.
THE ART-3000 Rotator:- In good condition, serviced & upgraded.
Completely stripped down to the last nut, bolt & screw, then cleaned & checked all part for damage etc. Replaced faulty motor, Replaced & upgraded original 360 degree POT with a new POT + divider & drive gear configuation from Emotator, Upgraded cork brake pads with better versions, Install the motor start CAP & fully re-wired. Control cable is now 7 core instead of 8. All gears are in very good condition. Replaced the ball bearings with new & reassembled with new grease through out.
Re-aligned & calibrated to the controller.
Supplied with original 8 pin plug & weather boot.
Mains input voltage 240v AC. 12 month warranty.


Details

Manufacturer AIGA
Model ART-3000c-DS
Condition of Item Good
Accessories Included Top mast clamp & hardware, Plugs for control cable, IEC power lead + revised manual
Postage / Freight Pickup Available





Advertisement

<< Previous Next >>