Category: Main > Commercial - Dealer Only > Rotators

DAIWA DR-7500 Rotator & DC-7011 Controller  - $450 Listing ID: 14517



Classified Info

Listing Began: Jul 4 16:57
Number of Times Viewed: 180

02-07-001a.jpg

  • 02-07-001a.jpg
  • 02-07-003a.jpg
  • 02-07-007a.jpg
  • 02-07-008a.jpg
  • 02-07-011a.jpg
  • 02-07-012a.jpg
  • 02-07-013a.jpg
  • 02-07-018a.jpg

Options

  • $60

Description

Seller's Comments and Description:

DC-7011 controller & DR-7500 rotator with new top mast clamp.
Fully Re-built, Refurbished & Upgraded. Includes Mounting/clamping hardware, Plug & terminals for control cable & revised manual.
Control cable is 6 core, NOT included. I can make up cable to length, please contact me with your requirements.
WIND AREA:- 1.0m Sq.
ROTATION TORQUE:- 5kg/m
BRAKE TORQUE:- 20kg/m
MAST SIZE:- 38 ~ 63mm
ROTATION TIME:- 60 seconds for 360 degrees
ROTATOR VOLTAGE:- 24v AC

The DC-7011 Controller:- Refurbished & Upgraded.
Completely disassembled the cleaned & prept for upgraded etc. The chassis & all metal parts were then zinc plated, then reassembled.
The PCB has been upgraded with a enclosed AC fuse holder (for safety) & the meter alignment POT was replaced with a 10 turn version, to make alignment easier.
Replace the old globe illumination with an LED strip & installed there power supply PCB. Replaced cracked gear in display drive train.
On the rear panel:- The screw terminal board was stripped, cleaned, painted & had replacement phillip screw terminals installed. Replace the original power lead with an approved safety plug version, also added an earth terminal.
Re-wired then re-calibrated & aligned with the rotator.
The DR-7500 Rotator:- Refurbished & upgraded etc with new late model top mast clamp.
Completely disassembled, cleaned & clecked all parts for damage. 
The 3 stack final drive gear was upgraded to 4 stack & spacer this gives more contact area onto the rare ring gear. Fully re-wired including adding limit switches.
The housings & the new mast clamps were Glass Bead Blasted, etch primied then painted in epoxy gloss enamel (Pewter). Re-assembled with new ball bearings & new grease was applied through out.
Re-aligned & calibrated to the controller.
220v AC. Two year warranty.


Details

Manufacturer DAIWA
Model DR-7500 & DC-7011
Condition of Item Excellent
Accessories Included New top mast clamp & clamping/ mounting hardware + Plug & terminals for control cable
Postage / Freight Pickup Available





Advertisement

Next >>