Category: Main > Commercial - Dealer Only > Rotators

EMOTATOR 105TSX Rotator Set Refurbished & Upgraded  - $450 Listing ID: 14244



Classified Info

Listing Began: Jun 14 16:56
Number of Times Viewed: 88

20-05-001b2.jpg

  • 20-05-001b2.jpg
  • 20-05-004a.jpg
  • 20-05-006a.jpg
  • 20-05-008a.jpg
  • 20-05-10a.jpg
  • 20-05-011a.jpg
  • 20-05-012a.jpg
  • 20-05-014a.jpg

Options

  • $60

Description

Seller's Comments and Description:

Rotator With Standard Full Circle Controller, Refurbished & Upgraded etc.
Includes top mast clamp, plugs for control cable & IEC power lead plus revisied manual.

Wind Area...................1.0m Sq
Rotation Torque............6.0 kg/m
Brake Torque...............30 kg/m
Mast Size....................31 ~ 61mm dia.
Rotation Time..............50 seconds 360 degrees
Rotator Voltage............24v DC
Controller voltage.........240v AC.

The rotator set is suited for small HF yagis etc & VHF/UHF arrays etc.

The TSX Controller:- 
Full circle display with momentry & lift to lock direction switch.
Disassembled, cleaned & prep chassis for upgrades & new parts.
The back panel:- Install a new 8 pin Cinch socket mounted on a laser cut S/S cover/mounting plate, new fused IEC 240v socket & a earth bolt.
On the inside:- Upgraded the display illumination with 2 x 3 LED modules & there power supply.
Refurbished the POT, replaced the direction micro switches + re-wiring.
Re-assembled, fully tested & aligned with the rotator.
THE 105 Rotator:- Has a 24c DC motor.
Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.
All housings & the mast clamp bracket etc have been cleaned, then Glass Bead Blasted by IMPACT GLASS BEAD followed by etch priming, then painting in Epoxy Enamel (aluminium) & finished off in a few coats of clear enamel paint.
The stainless steel 'U' bolts & hardware were cleaned in a special solution.
Replaced the original terminal block & cover with a IP67 5 pin socket mounted on a laser cut S/S plate.
Replaced the limit switches & refurbished the POT, then rewired to the new 5 pin socket.
The gears were aligned & shimmed into the chassis, then re-assembled into the refurbished housings with new ball bearings & new grease through out.
Re-aligned & calibrated with the controller.
240v AC. 24 month warranty.
This unit is available for exchange, see details on my web site.
Contact Peter of Duoro Services, Mob. 0427 043 054


Details

Manufacturer Emotator
Model 105 TSX-DC
Condition of Item Excellent
Accessories Included Top mast clamp & hardware, Plugs for control cable, IEC power lead + revised manual
Postage / Freight Pickup Available





Advertisement

Next >>