Category: Main > Commercial - Dealer Only > Rotators

EMOTATOR 105LBX Rotator Set Refurbished & Upgraded  - $400 Listing ID: 14243



Classified Info

Listing Began: Jul 26 22:20
Number of Times Viewed: 591

12-06-001a1.jpg

  • 12-06-001a1.jpg
  • 12-06-005a.jpg
  • 12-06-006a.jpg
  • 12-06-009a.jpg
  • 12-06-010a.jpg
  • 10-06-010a.jpg
  • 10-06-011a.jpg
  • 10-06-018a.jpg

Options

  • $60

Description

Seller's Comments and Description:

Rotator With Standard Panel Meter Controller, Refurbished & Upgraded ETC.

Includes top mast clamp, plugs for control cable, IEC power lead plus revisied manual.

Wind Area......................1.0m Sq
Rotation Torque...............5.0 kg/m
Brake Torque...................30 kg/m
Mast size.........................31 ~ 61mm Dia.
Rotation Time...................65 seconds 360 degrees
Rotator Voltage.................24v AC
Controller voltage..............240v AC

This rotator set suited for small HF yagis etc & VHF / UHF arrays etc.

The LBX Controller:- Panel meter display with momentary & lift to lock direction switch.
Disasembled, cleaned & prep chassis for upgrades & new parts.
The back panel:- Installed a new 8 pin Cinch socket & laser cut S/D cover/mounting plate, New fused IEC socket & earth bolt.
On the inside:- Upgraded the display illumination with a 3 LED module & there power supply. Moved the motor start CAP to the rotator. Replaced the direction display panel meter (that didn't work) with one from a Emotator CXX controller, replaced the damaged original PCB with an upgraded version form a Kenpro KR-400.
Re-assembled, fully tested & aligned with the rotator.
The 105 (24v AC) Rotator:- Has a cork pad lift disc brake system mounted on top of the motor.
Disassembled to the last nut, bolt & screw. Cleaned & checked all parts for damage.
Installed new limit switches as this model didn't have any, Also install the motor start CAP, replaced the 600 ohm POT with a new 500 ohm version to suit the controllers replacement PCB.
All housings & mast clamps/brackets have been cleaned then Glass Bead Blasted by IMPACT GLASS BEAD followed by painting in clear enamel.
The stainless steel 'U' bolt & hardware were cleaned in a special solution.
Replaced the original controll cable terminal block & cover with a IP67 7 pin round socket mounted on a laser cut S/S mounting plate.
The gears were aligned & shimmed in there chassis, then re-assembled into the refurbished housings with new bearings & new grease through out.
Re-aligned & calibrated with the controller.
240v AC, 24 month warranty.
This rotator Set is available for exchange, view details on my web site.


Details

Manufacturer Emotator
Model 105LBX
Condition of Item Excellent
Accessories Included Top mast clamp & hardware, Plugs for control cable, IEC power lead + revised manual
Postage / Freight Pickup Available





Advertisement

<< Previous Next >>