Category: Main > Commercial - Dealer Only > Rotators

EMOTATOR 502TSX Rotator & Controller. REDUCED  - $500 Listing ID: 13121



Classified Info

Listing Began: Apr 7 20:46
Number of Times Viewed: 42
  • 01-031a.jpg
  • 03-033a.jpg
  • 04-040a.jpg
  • 19-08-025a.jpg
  • 19-08-036a.jpg
  • 19-08-043.jpg
  • 19-08-045a.jpg
  • 19-08-034a.jpg

Options

  • $60

Description

Seller's Comments and Description:

REDUCED SAVE $100.00.
Full Refurbishment & Upgrade.
Includes top triple clamping mast clamp, plugs for control cable & IEC power lead.

Wind Area ............. 1.5m Sq.

Rotation Torque ..... 6.0kg/m.
Brake Torque ......... 40kg/m.
Rotation Time ........ 66 seconds 360 degress,
Mast Clamp ............ 38 ~ 63mm.
Rotator Voltage ...... 24vAC.

The TSX Controller
:- 24v AC output, Full circle display with momentary & lift to lock direction switch.
Disassembled, cleaned & prep chassis for upgrades & new parts.
The back panel:- Installed a new 8 pin Cinch socket & laser cut S/S cover/mounting late, new fused IEC 240v socket & earth bolt.
On the inside:- Upgraded the display illumination with 2 x 3 LED modules & there power supply, refurbished the display POT. Reassembled, fully tested & aligned with the rotator.

The 502 Rotator
:- With 24v AC motor & has a drag spring brake system mounted on top of the motor.
Completely disassembled, cleaned & checked all parts.
All housings were Glass Bead Blasted, etch primied & sprayed in silver hammer tone paint.
Since this rotator didn't have any mast clamps when I purchased it, I used a set I had in stock which had been glass bead blasted & powder coated in silver ripple.
Replaced the original control cable plug/socket & cover with a IP67 7 pin round socket mounted on a laser cut S/S cover/mounting plate.
The burnt out 100v AC motor was replaced with a 24vAC version with new motor start CAP, replaced the limit switches & refurbished the POT.
The following parts were re-zinc plated:- Top gear plate, motor mounting plate, limit switch mount & Z bracket plus the POT divider gear.
The gears were aligned & shimmed then re-assembled into the refurbished housings with new bearings & new grease through out. Aligned & calibrathed with the controller.
240v AC. 12 month warranty.
This rotator set is available for exchange (see details on my web site).
Contact Peter of DUORO SERVICES on 0427 043 054.


Details

Manufacturer EMOTATOR
Model 502TSX
Condition of Item Excellent
Accessories Included Top mast clamp & hardware, Plugs for control cable, IEC power lead
Postage / Freight Pickup Available





Advertisement

<< Previous